Contains information about the dynamic sensors, including sensor type and location. (SPU refers to the 6 signal processing units, which acquire the dynamic sensor data.)
||Sequential number used for sensor identification
||Name assigned to the sensor. The first letters identify the sensor type: VD = vertical displacement; EG = embedded (strain) gage.
||Gives information on the sensor type, including sensor units.
||The test item where the sensor was located. Refer to the test area diagram.
||Sensor location x coordinate (feet). Refer to the test area diagram.
||Sensor location y coordinate (feet). Refer to the test area diagram.
||Sensor location z coordinate (inches). Refer to the test area diagram.
||Number of the signal processing unit (SPU) used to acquire dynamic data from SensorName. SPUs are numbered 1 – 6.
||Data acquisition card within the SPU used to acquire data from SensorName. There are two acquisition cards in each SPU.
||Calibration factor A (for software data processing).
||Calibration factor B (for hardware data processing).
||May include specific information about a sensor, including dates for which sensor data are available in the database.